Press the connect button to connect the CRO and Function Generator with wire
Toggle the On/Off Switch to on the CRO for display
Toggle the switch to on the Function Generator for setting the signals
Answer the question poped up and then choose the type of signal
Choose the correct answer and then set the amplitude of the signal
Choose the correct answer and then set the frequency of the signal
Answer the MCQ and change the x-position to move the signal sidewards
Change the x-division to change the width of the signal
Change the y-position to move the signal up and down
Choose the correct answer and then change the y-position to change the height of the signal
Toggle the switch to view the signal as vertical line to calculate the amplitude
Switch off the XY switch and toggle the focus switch to view the signal as Horizontal line
Click to remove the wire and disconnect the CRO and function generator.Consider each division in the CRO axis as 16 units and measured signal parameter is displayed
1.)How do you calculate the RMS voltage of a Sine Wave?
2.)If the peak-to-peak value of sine wave is 60V what is the RMS value ?
3.)If frequency = 10Hz, what is the time period?
4.)The total area under the complete sine wave curve divided by the distance of the curve is known as?
5.)What is the RMS value of sawtooth wave if the peak value is 20V?
*The lab is developed as a nodal center of NITK Vlab
Time Period(s)
Peak-to-Peak Voltage(V)
RMS Voltage(V)
Average Voltage(V)
Peak Voltage(V)
We acknowledge the NITK and PALS for extending their support towards successful completion of the experiment
